Specifications

- The dragsters must have a mass of 50 grams or more without the CO₂ cartridge.

- When complete the total length of the dragster should be no more than 310 mm in length. It should also be no more than 80 mm wide, from wheel to wheel..

- The cartridge hole must be 50 mm deep and 19 mm in diameter. The hole of the cartridge must be at least 33 mm from the floor and no more than 43 mm. There should be at least 33 mm of wood around the entire cartridge hole.

- Each dragster must have two small screw eyes inserted at the base of the vehicle. One towards the front and one toward the back of the centerline.

- The dragster must be made of solid or laminated wood.

- Bearings and lubricants can be used on the vehicle.

- The dragster must have at least 3 wheels made of plastic with a maximum diameter of 2cm

- Each dragster must have two axles and each axle must pass through the body of the dragster.